The Peavey Valverb is considered by some to be the best American made, non-Fender, all-tube reverb unit to be made. It was made in the 1990’s and no longer in production. Highly sought after on the used market. Here is one fine example:
Update: Just added some new shots of the chassis, tubes, board, Orange Drop caps, Fisher speaker, etc.
The Original 40XL
This page is dedicated to photos of our ’69 Silvertone 1422, also known as the Sears 40XL. We recently acquired this amp and found it to be one of the nicest 40XL’s we’ve seen in many a year. This Made-in-USA amp is totally original, right down to it’s late 60’s dark olive vinyl, green sparkle grille cloth, and a 12-inch Alnico magnet made by Fisher. The only cosmetic damage we could find is a bump (dimple) on the cabinet edge, right side of the control panel, and a chip off one control knob.
The 1422, or 40XL, was marketed by Sears as a 40-watt, 12-inch, combo tube amp for guitar. It features two separate input channels, and built-in reverb and tremolo. The reverb and trem are controlled by a dedicated foot switch. Sears advertised these as 40-watt combo amps. But in reality, the two 7189 power tubes put out around 20-watts or less. In fact, the features and chassis layout suggest that it could be an American copy of a the mid-60’s Marshall Model 1974, which was an 18-watt combo using two 6BQ5’s (EL84’s).
Summer of ’69
This amp was built, sold, and first played in the Summer of ’69. The code on the CTS potentiometers read “137-6919.” Decoded, that means “137” = Mfr’d. by CTS; “69” = Year Mfr’d. (1969). “19” = Week Mfr’d. (2nd Week of May).
How Does It Sound?
Well, it’s a loud 18 to 22 watts, that’s for sure. HUGE in the mid range, solid in the bass range, but not too sparkly or chimey at the high end. Poor speaker sounds like it’s wearing a heavy wool sweater. And there is a noticeable 60-Hz hum. But we will dig into it and find out what’s wrong.
Major improvements! We took the chassis out of the cabinet, cleaned and tightened all the loose connections, and relocated one unshielded cable sitting too close to the transformer (will completely remove that later). Now, the amp is almost silent when idling, the 60-Hz hum is completely gone, and frequency response at the high and low ends have improved!
These photos are little rough, and I hope to upload some better ones in the near future.